Select Page

CellarPro 3400H-ECX
Houdini Cooling Unit


  • 3492 BTU/h¬†
  • Dimensions:¬†¬†Width¬†46, Depth 13, Height 14 1/2h (in)
  • Ideal for small wine cellars and wine closets
  • Shallow height and depth
    • Fits shallow glass enclosures
    • 13‚Ä≥D x 14 1/2‚Ä≥H
    • 46‚Ä≥W
CellarPro’s 3400H-ECX Houdini Wine Cooling Unit (1/2 Ton Nominal) is designed specifically for¬†glass-enclosed wine cellars, and uses¬†energy-efficient variable-speed EC fans¬†for maximum performance. Features include:

  • Shallow height and depth
    • Fits shallow glass enclosures
    • 13″D x 14 1/2″H
    • 46″W
  • Houdini Wine Cooling Unit Can be placed inside the cellar, atop the cellar, partially installed in the cellar ceiling, or completely remote from the cellar (requires duct kit)
    • Choice of airflows for cold side
      • Intake from bottom, left, front, or top side
      • Exhaust from bottom, front, or top side
      • Air deflector optional
    • Choice of airflows for hot side
      • Intake from right, front, or top side
      • Exhaust from front, rear, or top side
      • Air deflector optional
  • Houdini Wine Cooling Unit has energy-efficient variable-speed EC fans with independent controls – choose between performance vs noise
    • Hot side – higher ambient temps require high fan speed
      • Low fan speed: 56 dBA / 85F maximum intake temperature
      • High fan speed: 61 dBA / 95F maximum intake temperature
    • Cold side – higher cooling load requires high fan speed
      • Low fan speed: 2737 SENSIBLE BTUH @ 55F / 47F lowest achievable cellar temperature
      • High fan speed: 3492 SENSIBLE BTUH @55F / 47F lowest achievable cellar temperature on hot, cold or both sides
  • Oversized stainless-steel drain pan with 200W heating element
    • Included as standard equipment
    • No drain line required for properly constructed, airtight cellars
    • Optional overflow drain fitting and 8′ flexible drain line
  • Choice of power source
    • Side or rear
    • Removable 10-ft cord
  • Optional remote display
  • Optional bottle probe (highly recommendedunless the unit is configured with the networkable thermostat upgrade)

Please note:
If the cooling unit is partially or fully exposed to an environment outside the cellar, especially if the cooling unit will be located in an unconditioned or warm, humid environment, we recommend insulating the left 20-inches of the cooling unit with 1-inch closed-cell foam insulation (R-4 or better).

Our cooling units are designed to be used in properly-constructed wine cellars that are adequately insulated, airtight and sealed with a vapor barrier. In improperly-constructed cellars, the cooling unit will create excess condensation, leading to damage and premature failure of your cooling unit (not covered by warranty).



  • CellarPro 3400H-ECX Houdini Wine Cooling Units are self-contained, fully-charged¬†units designed to be attached to the ceiling inside the cellar, or above the cellar.
  • 3400H-ECX Houdini Wine Cooling Unit also can be located remotely¬†from the cellar with the addition of one of our cold-side duct packages. Offered with or without insulated flex ducting, in a choice of configurations for low or high humidity conditions, our cold-side duct packages allow these cooling units to be¬†ducted up to 50 equivalent feet¬†away from the cellar and require 8-inch (or greater) ducting from start to finish.
  • When calculating equivalent feet,¬†each 90-degree turn counts for 8 feet.
  • For remote or inaccessible installations, we offer a remote control display kit which is wired to the cooling unit and allows the digital display to be mounted inside or outside the cellar.
  • 3400H Houdini Wine Cooling Unit require fresh air intake¬†without interference from the unit’s hot air exhaust. If sufficient space does not exist to provide fresh air, you may need our hot-side duct kit.
  • The cold side of the cooling unit should never be exposed to temperatures below 32F.
  • Houdini Wine Cooling Unit must always be used in the upright position, and should never be operated on its side or upside down.

Brand: CellarPro

UPC: 077757358562

Size: 46w x 13d x 14 1/2h (in)

115V AC / 60 Hz
Compressor Amps:
– Startup (LRA): 40.0 Amps
– Unit Amp Rating: 10.26 Amps
– Total Watts with Fans on Low: 807
– Total Watts with Fans on Low: 791
– Compatible with Dedicated 15-Amp Circuit

BTUH @ 55F:
– Low Fan Speed: 2737BTUH
– High Fan Speed: 3492 BTUH
– 1/2 Ton Nominal

Warranty Resources
–¬†Warranty Overview

Click on one of the following links for more information:

WARNING - This product can expose you to chemicals including Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to


CellarPro 3400H-ECX Cooling Unit (P/N 35856). CellarPro engineered the 3400H-ECX cooling unit specifically for shallow-depth glass wine cellars.

Just 13-inches deep and 14 1/2-inches tall, the 3400H-ECX Houdini cooling unit is designed to “disappear” inside – or atop – the cellar. Dual independent variable-speed fans offer flexibility to trade-off between super-quiet operation vs maximum performance.

For example, assuming 75F ambient temperature, R13 insulation in the non-glass walls and no ducting, the 3400H-ECX would work in the following cellars:

Cellar Dims
Cu Ft

Glass Sq Ft
Glass Pane

13’w x 2 1/2’d x 9’h ¬† 293 117 (Front Wall) ¬† Single 60F 3460
15’w x 2 1/2’d x 10’h ¬† 375 150 (Front Wall) ¬† Double 55F 3308
15’w x 2 1/2’d x 10’h ¬† 375 200 (Front & Side Walls) ¬† Double 58F 3326

All air-cooled refrigeration equipment requires fresh air intake to dissipate the heat generated by the cooling unit. The fresh air intake CANNOT come from the wine cellar space – it must come from space outside the cellar.

Variable-speed fans with independent control provide maximum flexibility and versatility, as follows:

  • Features¬†energy-efficient EC Fans¬†on both the cold and hot sides
  • This unit can be configured to pull fresh air ranging from¬†-20 to 95F. If the unit’s location does not provide sufficient room for the unit’s exhaust to dissipate and/or fresh air to be provided, you may need to purchase a hot-side duct kit. We recommend the addition of a fan cycling switch when fresh air intake will be below 20F.
  • The unit must be placed indoors in an area that is above 32F.
  • Dual high-output fans come with independent variable speed settings for¬†your choice of maximum cooling power¬†at the high fan speed,¬†or super-quiet operation¬†(56 decibels) at the low fan speed.
  • Adjustable humidity control¬†combines a high-output compressor with flexible fan cycles to maintain a recommended level of moisture inside your cellar.
  • Custom coils generate¬†maximum cooling power¬†inside the cellar.
  • Excess condensate is managed with a high-capacity stainless steel condensate pan and 200W electric heating element.
  • Commercial-grade¬†Electrofin coating¬†protects the evaporator coils from leaks and corrosion.
  • Intuitive¬†LED display panel¬†mounted on the evaporator with¬†digital programmable thermostat¬†is simple and easy to use. Remote thermostat is available as an upgrade.
  • Energy-saver mode, quick-chill mode, and auto-defrost cycle provide convenient solutions to common cellar needs.
  • Temperature set point range is¬†47F to 62F¬†when the cooling unit is properly sized.
  • Unit operates with¬†minimal vibrations¬†and¬†less noise¬†than comparable units from competitors.
  • Audible and visual alarms and maintenance-needed indicator protect the cooling unit and the wine cellar.
  • With dual power sources and a 10-foot power cord, the unit can be plugged into a receptacle from either the rear or right side of the cooling unit, providing flexibility for most installations.
  • Common¬†dedicated 15-amp circuit¬†is required to power the unit.
  • Mounting brackets, included as standard equipment, ensure easy installation.
  • Removable steel case¬†provides access to the internal components for servicing and repair.
  • CellarPro’s 5-Year Standard Warranty,¬†the most thorough in the industry, protects the unit against manufacturing defects.
  • An optional Extended Warranty (P/N 31488) is available for additional protection.
  • ETL¬†Tested and Certified¬†to rigorous UL Standards for safety.

Cold Temperature

  • Compressor Heater #1727:¬†protects the unit when installed in environments that drop below 40F down to 20F.
  • Fan Cycling Switch #6972: supports the unit in temperatures below 20F and as low as -20F when combined with our compressor heater.

Duct Hoods

  • Hot Side Duct Hood#36026¬†and Kit¬†#36027: allows you to install the unit in a small space with limited airflow, and duct the airflow up to 100 equivalent feet (50 feet per duct)
  • Hot Side Duct Kit w/ Inline Fan#36028: allows you to install the unit in a small space with limited airflow, and duct the airflow up to 200 equivalent feet (100 feet per duct)
  • Cold Side Duct Hood#36024¬†and Kit¬†#36025: permits the cooling unit to be located remotely, up to 50 equivalent feet away from the cellar (cold side), and duct the airflow up to 100 equivalent feet (50 feet per duct)
  • Duct Kits are the same as Duct Hoods, and also include 2 x 25-feet of 8-inch insulated (R-6) flex ducting.

Filters & Grills

  • Use our¬†filter & grill guide¬†to find the cooling unit filter or duct filter and/or duct grill that is appropriate for your cooling unit.

Remote Control & Probe

  • Networkable Thermostats¬†#27346¬†and¬†#2710: Included as standard equipment allowing connection of your cooling unit to a networkable, Wi-Fi enabled thermostat (sold separately,¬†Ecobee SmartThermostat Pro #31453).¬†Must be ordered at the same time that the equipment is ordered.¬†Other limitations apply – read the networkable thermostat description for more information.
  • Remote Display #1603: lets you place the digital panel wherever you want, whether inside or outside the cellar. Includes 10 feet of wiring.
  • Bottle Probe #1434: this remote thermostat with a 10-foot cord overrides the thermostat on the face of the cooling unit, and allows it to monitor air or liquid temperatures at various locations inside the cellar. The bottle probe is¬†highly recommended¬†unless the unit is configured with the networkable thermostat upgrade
  • Extension cords available in 25-foot¬†(#1780)¬†and 50-foot¬†(#1781)¬†lengths.

Other Options & Upgrades

  • Condensate Drain Line: strongly recommended for wine cellar installations that are not airtight, a drain line allows excess moisture to drain from the the cooling unit¬†(#1606).

Nobody protects your wine cellar better than CellarPro Cooling Systems! In the event your cooling unit fails and the failed components are covered by our warranty, we’ll send a replacement cooling unit to you per the terms of our¬†Replacement Unit Program

CellarPro Replacement Unit Program
If your CellarPro cooling unit fails and the parts that failed are still covered by warranty, we’ll send a replacement cooling unit to you, as follows:

  1. Your cooling unit must be registered at CellarPro
  2. Your cooling unit must have been properly sized, installed and maintained
  3. Your cooling unit may not have been permanently modified, damaged or disfigured

Please note:

  • Replacement units are factory-refurbished cooling units with a similar build date as your original unit
  • You are responsible for the shipping cost to send the replacement unit to you and return the original unit to us, and the cost (if any) to remove the original unit and install the replacement unit
  • In order to send a replacement unit, we require a deposit, which will be refunded minus shipping costs upon the return and pending the inspection of the original unit
  • If the original unit failed due to improper installation or use, the failure is not covered by warranty and we will deduct the cost of the repairs from the refund of your deposit.