Select Page

Breezaire WKSL 2200

$3,156.00

Enclosure      Electrical      Dimensions (in)                            Weight
Model              Volume (max)
WKSL 2200
Fan/Coil            265 cu.ft.            1 Amp          14.25W x 14.125H x 7.75D               25 lb.
WKSL 2200
Condenser        265 cu.ft.             4 Amps       14.25W x 14.125H x 11.00D             35 lb.

When our self-contained series will not meet your needs then the Breezeair WKSL split design will provide the flexibility needed to create an ideal installation or deal with unusual site problems. Breezeair WKSL Series cooling systems are special split systems that allow mounting of the cooling (evaporator) module in the enclosure to be cooled and the exhaust (condenser) module as far as 50 feet away.

The systems are designed – when installed in a properly constructed enclosure – to provide a constant selectable temperature between 48 and 63 degrees Fahrenheit while maintaining 50 to 75 percent relative humidity. WKSL Series systems are designed for easy installation by any, properly equipped, qualified air conditioning or refrigeration service technician.

Two copper tubes connect the two modules and power is hard wired to the units using adequately sized 110 AC volt electrical source. These systems must be charged with refrigerant during installation. The WKSL series uses BREEZAIRE’s rugged adjustable mechanical thermostat. Professional installation skills and equipment required.

HUMIDITY & INSTALLATION:

By the nature of their operation, wine cooling units will maintain a stable humidity level, lower than the relative ambient humidity. In situations where the ambient humidity is high, the cooling unit will lower the humidity to desirable storage levels.

In situations where the ambient relative humidity is very low, the desired enclosure relative humidity may not be achieved without adding moisture. To add moisture to the enclosure only use slow, natural evaporation from a small porous water container. Do not use a humidifier.

TEMPERATURE & INSTALLATION:

These Breezeair wine cellar cooling units are designed to cool 25 degrees less than the ambient temperature of the venting side of the unit. In some cases, improper placement or installation may cause the unit’s performance to be degraded.  The condensing unit must have a constant supply of fresh air, less than 85 degrees F.

If the condensing unit is located in a confined area with poor ventilation, the unit will not be able to reject the heat it is removing from the enclosure and a malfunctioning unit will be suspected, even though the unit is mechanically sound. Call us to discuss your installation concerns.

SENTRY III CONTROL SYSTEM FEATURES

  • Large, easy to read, cool green LED display
  • Accurate, easy to adjust temperature set points with continuous display of cabinet temperature.
  • Power outage protection.
  • Blocked airflow protection, which shuts down unit and protects wine in case of high temperatures caused by condenser blockage or fan failure.
  • Controls temperature by enclosure (cellar) air sensors or optional bottle probe.

Adjustable Temperature

Breezeair systems are designed to maintain the air temperature between 50 and 60 degrees Fahrenheit, the ideal temperature for storing wine. Every unit is user-adjustable for precise control, and the cooling units will always produce a gentle stream of cool air rather than cold. This protects your wine from sudden temperature changes.

Automatic Humidity Control

Humidity is vital to the maintenance of your corks, and thereby vital to the health of your aging wines. Breezaire systems are designed to maintain humidity at the levels ideal for wine aging while eliminating excess moisture. Additional humidification may be needed in dry climates.

Vibration-Free Operation

Breezeair systems are all hand-assembled and tested to ensure that they meet the highest standards. Vibrations that may be undetectable to the cellar owner can affect the quality of the wines, so Breezaire strives to eliminate all vibration from their units.

Ultra Quiet Operation

Walking into your wine cellar should feel like walking into a wonderful cave of wine. To preserve that feeling, Breezaire systems are designed to be ultra-quiet and unobtrusive.

Attractive Metal Cabinet

The housing of the cooling unit is sleek and attractive, and will blend into any decor. The unit can be mounted flush with the wall.

Ease of Installation

The most popular Breezaire units are the self- contained units, which are simply mounted and plugged into a 115AC electrical source. No complicated wiring or procedures required.

Uncompromising Quality

Breezeair systems are designed, built and tested to deliver the highest standard of performance. They are built from top quality materials and components and hand-assembled in the U.S.A.

Comprehensive Warranty Coverage

Get peace of mind with a Breezaire warranty (See Warranty tab for details).

Capacity
Enclosure Volume 256 CF

Key Features
High Temperature Alarm Yes
Electronic Controls Yes
Digital Temperature Display Yes
Humidity Control Yes
Fancoil (Split Systems)

Dimensions
Height 14.125″
Width 14.125″
Depth 7.75″
Weight 25 lbs.
Electrical Requirements 110 V / 60 Hz

Condenser (Split Systems)
Height 14.125″
Width 14.125″
Depth 11″
Weight 35 lbs.
Electrical Requirements 110 V / 60 Hz
Electrical
Electrical Requirements 110 V / 60 H